2000 SeaDoo GS (5644,5827), GSX RFI (5645,5654), GTI (5647,5657), GTS (5639), GTX (5653,5690), GTX RFI (5648,5658), XP (5651,5655) Operator's Guide

2000 SeaDoo GS, GSX RFI, GTI, GTS, GTX, GTX RFI, GTI, XP Operator's Guide Contents:

FOREWORD SAFETY WARNING General Operation Maintenance LIST OF DISTRIBUTORS BOMBARDIER LIMITED WARRANTY NORTH AMERICA 2000 SEA-DOO® BOMBARDIER INTERNATIONAL LIMITED WARRANTY 2000 SEA-DOO® REGISTRATION NUMBER LOCATION LOCATION OF THE IMPORTANT LABELS IDENTIFICATION NUMBERS Hull Engine CONTROLS AND COMPONENT LOCATION COMPONENTS FUNCTIONS 1) Safety Lanyard 2) Handlebar 3) Throttle Lever 4) Engine Start/Stop Button 5) Variable Trim System Button (VTS) (if so equipped) 6) Choke Lever 7) Shift Lever (if so equipped) 8) Fuel Gauge/Low Oil Warning Light (if so equipped) 9) Speedometer (if so equipped) 10) Tachometer (if so equipped) 11) Variable Trim System (VTS) Gauge (if so equipped) 12) Info Center Gauge/Buttons (if so equipped) 13) Glove Box (if so equipped) 14) Fuel Tank Valve 15) Fuel Tank Cap 16) Oil Injection Reservoir Cap 17) Front Storage Compartment Cover 18) Front Storage Compartment Cover Latch 19) Front Storage Compartment Cover Hinge/Locking Mechanism 20) Front Storage Compartment Cover Lock (if so equipped) 21) Tool Kit 22) Storage Compartment/Engine Cover (if so equipped) 23) Storage Compartment/Engine Cover Latches (if so equipped) 24) Water Tank Trap Drains (if so equipped) 25) Air Intake Opening 26) Rear Vent Grills (if so equipped) 27) Seat Strap 28) Seat Latch 29) Rear Seat Latch (if so equipped) 30) Rear Grab Handle 31) Rear Storage Basket (if so equipped) 32) Rear Access Cover (if so equipped) 33) Bow and Stern Eyelets 34) Mooring Cleats 35) Cargo Cleats (if so equipped) 36) Footboard 37) Boarding Pads 38) Boarding Platform 39) Boarding Step (if so equipped) 40) Cooling System Bleed Outlet 41) Flushing Connector (if so equipped) 42) Bilge Drain Plugs 43) Automatic Bilge Pump (if so equipped) 44) Jet Pump Nozzle 45) Reverse Gate (if so equipped) 46) Jet Pump Water Intake FUEL AND LUBRICATION Fueling Procedure Recommended Fuel Recommended Oil Oil Injection System BREAK-IN PERIOD Engine 10-Hour Inspection DAILY PRE-OPERATION CHECKS Hull Jet Pump Water Intake Bilge Battery Fuel Tank and Oil Reservoir Engine Compartment Steering System Throttle System Shifter System (if so equipped) VTS (Variable Trim System) (if so equipped) Safety Lanyard and Engine Start/Stop Button Storage Compartment Covers OPERATING INSTRUCTIONS Principle of Operation Boarding the Watercraft Starting the Engine Rough Water or Poor Visibility Operation Crossing Waves Stopping/Docking Beaching Shutting Off the Engine POST-OPERATION CARE General Care Additional Care for Foul Water or Salt Water Cooling System Flushing and Engine Internal Lubrication Anticorrosion Treatment SPECIAL PROCEDURES Engine Overheating Jet Pump Water Intake and Impeller Cleaning Capsized Watercraft Submerged Watercraft Water-Flooded Engine Fuel-Flooded Engine Towing the Watercraft in Water Low-Charge Battery Condition MAINTENANCE Lubrication Periodic Inspection Periodic Inspection Chart Throttle and Choke Cable Inspection Carburetor Adjustment Fuel and Oil Filters Steering Alignment VTS Adjustment (if so equipped) Vacuum Bailer Pick-Ups Water Tank Trap Drains Fuses General Inspection and Cleaning TRAILERING, STORAGE AND PRE-SEASON PREPARATION Trailering Storage Pre-Season Preparation TROUBLESHOOTING SPECIFICATIONS SI METRIC INFORMATION ABBREVIATIONS USED IN THIS MANUAL CHANGE OF ADDRESS